Programming and Relearning

Reading off programmed values

Selecting the instrument type
Select one of the following alternatives (for kilometers or miles).

Hint: If the instrument speedometer is from 0 - 260, the instrument is intended for kilometers. If the gauge is from 0 - 160, it is intended for miles.

1. Kilometers
2. Miles.

Select the desired alternative.

1 - km

2 - miles

-------------------------------------------------

Checking the programmed values, km




- Ignition on.
When downloading software or replacing the combined instrument panel it is important to read off the customer's settings. This is so that the same data can be programmed again into the new combined instrument panel.
Read off and note the customer settings.
To program the customer settings again, see Programming the driver information module (DIM).





Continue - DONE

-------------------------------------------------

Checking the programmed values, miles




- Ignition on.
When downloading software or replacing the combined instrument panel it is important to read off the customer's settings. This is so that the same data can be programmed again into the new combined instrument panel.
Read off and note the customer settings.
To program the customer settings again, see Programming the driver information module (DIM).





Continue - DONE

-------------------------------------------------