Damper Motor, Recirculation, Replacing

Damper motor module (DMM) recirculation, replacing

The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.

Removal

Removing the damper motor module (DMM) for recirculation





Remove:
- the glove compartment. See Glove compartment, replacing Service and Repair
- the switch

Hint: Use a small electrician's screwdriver to pry up the switch by the lock. Depress the switch at the rear edge. Pull straight out.

- the 2 x screws
- the control module.
Check the functionality of the control module mechanism (1). Check that the arms for the dampers (2) are secure.

Installation

Installing the damper motor module (DMM) for recirculation





Install:
- the control module in position. Adjust the shaft journal in relation to the mechanism (1) so that it goes in
- the 2 screws. Tighten alternately
- the switch. Ensure that it is correctly positioned
- the glove compartment. See Glove compartment, replacing Service and Repair

Note! Identify the damper motor module (DMM) for recirculation. See VIDA vehicle communication.

Finishing

Testing the climate control system
Carry out a performance test on the climate control unit. See: Climate system, performance test Climate System, Performance Test