Checking Control of the Power Door Mirror

Checking control of the power door mirror

Checking the connectors




- Ignition off
- Check the power door mirror connector and connectors 54/10 and 54/11. Check for contact resistance and oxidation
- Ignition on.
Check that the power door mirror can be operated.

Other information:
- To access the connector for the power door mirror, see Door mirror, replacing Door Mirror, Replacing
- Checking wiring and terminals Checking Wiring And Terminals

Do the door mirror controls operate?

Yes - FAULT FOUND

No - Checking the components and wiring

-------------------------------------------------

Checking the components and wiring
Check the cable between control module terminal #5B and ground: Left or right seat support. Check for an open-circuit.
If a fault is found replace the cable.
If no fault is found, replace the power door mirror.

Other information:
- Signal specification Signal Specification, Driver Door Module (DDM) / Passenger Door Module (PDM)
- Connecting the breakout box Connecting the Breakout Box
- To access and replace the power door mirror, see Door mirror, replacing Door Mirror, Replacing
- Checking wiring and terminals Checking Wiring And Terminals

Continue - Symptom verification

-------------------------------------------------

Symptom verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Ignition on.
Test both the door mirrors to their limit positions using the controls. The mirrors should move in the corresponding direction.
After repairing power folding door mirrors:
Check whether the power door mirrors are synchronized by pressing the button for retraction and deployment of the mirrors.

Are the controls working?

Yes - Verification complete

No - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit Fault-Tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking the connectors

-------------------------------------------------