Not Calibrated

Not calibrated

Calibrating the component





Note! If the vehicle is equipped with Four-C, calibration must be carried out via suspension module (SUM).

Calibrate the position sensor for the Bi-Xenon lamps.
- Someone must sit in the driver's seat during calibration. The person must weigh at least 75 kg. Ensure that the car is unladen and is on a flat surface
- Ignition on
- Click on the VCT2000 symbol
- Calibrate the position sensor.









Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Ignition on.
Check that the position sensor for the Xenon lamp is calibrated by clicking on the symbol for VCT2000.





Is the position sensor calibrated?

Yes - Verification completed

No - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit Fault-Tracing

No - Attempt New Test

------------------------

Attempt New Test - Calibrating the component

-------------------------------------------------