Signal Too Low

Signal too low

Checking the wiring








- Ignition off
- Disconnect connector D on the rear electronic module (REM).
Check the signal cable. Check for a short-circuit to ground.
Take readings between:
- Rear electronic module (REM) terminal #D8 (#8) and terminal #7 on the connector for the rear left-hand lamp housing
- Terminal #7 on the connector for the rear left-hand lamp housing and terminal #7 on the connector for the rear right-hand lamp housing.
Remedy as necessary.

Other information
- Connecting the breakout box Connecting Breakout Box, Rear Electronic Module (REM)
- Signal specification Signal Specification, Rear Electronic Module (REM)
- Bulb tail lamp/stop lamp/back-up lamp/fog lamp, replacing Service and Repair
- Checking wiring and terminals Checking Wiring And Terminals

Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Ignition on.
Activate the stop lamp.
Check that the stop lamp is activated.

Is the stop lamp activated?

Yes - Verification completed

No - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit Fault-Tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking the wiring

-------------------------------------------------