Signal Too Low
Signal too low
Checking faults
- Ignition on.
Ensure that the button for the rear defroster is depressed.
Check that the defroster for the door mirrors is activated.
Is the defroster for the door mirror activated?
Yes - Intermittent fault
No - Checking for a short-circuit
-------------------------------------------------
Checking for a short-circuit
Check the cable between door control module terminal #11B and power door mirror terminal #8. Check for a short-circuit to ground.
Replace the cable if it is faulty.
Replace the power door mirror if the cable is OK.
Other information:
- Connecting the breakout box Connecting the Breakout Box
- Signal specification Signal Specification, Driver Door Module (DDM) / Passenger Door Module (PDM)
- Driver's door module / passenger door module (DDM/PDM), replacing Driver's Door Module/Passenger Door Module (DDM/PDM), Replacing
- Door mirror, replacing Door Mirror, Replacing
- Checking wiring and terminals Checking Wiring And Terminals
Continue - Verification
-------------------------------------------------
Intermittent fault
Check the control module and power door mirror connectors. Check for contact resistance, oxidation and loose connections.
Check the cable between control module terminal #11B and power door mirror terminal #8. Check for an intermittent short-circuit to ground.
Other information:
- Connecting the breakout box Connecting the Breakout Box
- Signal specification Signal Specification, Driver Door Module (DDM) / Passenger Door Module (PDM)
- Driver's door module / passenger door module (DDM/PDM), replacing Driver's Door Module/Passenger Door Module (DDM/PDM), Replacing
- Door mirror, replacing Door Mirror, Replacing
- Checking wiring and terminals Checking Wiring And Terminals
Continue - Fault-tracing information
-------------------------------------------------
Verification
Verification
Hint: After carrying out the repair, check that the fault has been remedied.
- Ignition off
- Reinstall the components, reconnect the connectors etc.
- Ignition on.
Ensure that the button for the rear defroster is depressed.
Check that the defroster for the door mirrors is activated.
Is the defroster for the door mirror activated?
Yes - Verification completed
No - Fault-tracing information
-------------------------------------------------
Fault-tracing information
Information
Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.
Do you want to exit fault-tracing?
Yes - Exit Fault-Tracing
No - Attempt New Test
------------------------
Attempt New Test - Checking faults
-------------------------------------------------
Fault-tracing information
Information
Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).
Do you want to view the information again?
Yes - Attempt New Test
No - Exit fault-tracing
------------------------
Attempt New Test - Checking faults
-------------------------------------------------