Signal Too Low

Signal too low

Checking the wiring




- Ignition off.
Check the power cable for a short-circuit to ground.
Take readings between:
- Central electronic module (CEM) #D9 and glove compartment lighting terminal #1.
Also check that the correct type of bulb is installed in the glove compartment lighting.
Remedy as necessary.

Other information
- Connecting the breakout box Connecting the Breakout Box, Central Electronic Module (CEM)
- Signal specification Signal Specification
- Location of components Locations
- Checking wiring and terminals Checking Wiring And Terminals

Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Ignition on.
Open the glove compartment.

Does the lamp light?

Yes - Verification completed

No - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit Fault-Tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking the wiring

-------------------------------------------------