Signal Too Low

Signal too low

Replacing the component
The central electronic module (CEM) has registered that the signal in the signal cable from the windshield wiper lever is too low.
If the fault is intermittent, it has been registered previously but is no longer present. Intermittent faults can be caused by interference at start up of the steering wheel module (SWM) or may be a different type of fault which occurs on different occasions. The fault is evaluated depending on how it occurs. If the fault recurs, replace the windshield wiper.
Washer / wiper switch, replacing Service and Repair
Remedy as necessary.

Continue - Verification

-------------------------------------------------





Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Ignition on.
Activate the windshield wipers.
Check that the windshield wipers are activated.

Are the windshield wipers working?

Yes - Verification completed

No - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit Fault-Tracing

No - Attempt New Test

-------------------------------------------------