Faulty Signal

Faulty signal

Checking the status
If the fault is intermittent, it has been registered previously but is no longer present. Intermittent faults can be caused by interference at start up of the steering wheel module (SWM) or may be a different type of fault which occurs on different occasions. The fault is evaluated depending on how it occurs. If the diagnostic trouble code (DTC) recurs, replace the turn signal lamp switch.

Other information
- Turn signal switch, replacing Service and Repair

Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Ignition on.
Activate the turn signal lamps.
Check that the turn signal lamps are activated.

Are the turn signal lamps activated?

Yes - Verification completed

No - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit Fault-Tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking the status

-------------------------------------------------