Passenger Door Module (PDM), Replacing

Passenger door module (PDM), replacing

Preparations

CAUTION: New software can only be ordered after the control module has been installed in the car. VIDA reads off the new control module identity which is required to order the correct software.

Always check that the control module and control module box connectors do not have bent or damaged terminals or sockets. This may have been the cause of the fault.

Removing the passenger door module (PDM)







Ignition off.

Remove:
- the door panel.
- the nut and screw holding the control module in place
- the connectors.

Grasp the underneath of the control module. Press upwards. Carefully pull the control module from the lower catches.







Release the upper catches using a weatherstrip tool. Lift out the control module.

NOTE: Check that the control module connectors are intact.

Installing the passenger door module (PDM)
Press the control module into place.

Install:
- the connectors
- the nut and screw
- the door panel.

Ordering software
Order software for the passenger door module (PDM).

Programming the control module
Program the new passenger door module (PDM).

Finishing
Initialize the window position in the communication input.