Fog Lamps

Fog lamps






















Fog lamps

Note! This accessory requires software unique to the car.

- Move the left front seat to the rearmost position
- Turn the ignition key to position 0.




- Raise the car.

Applies to cars with air baffles on the left and right-hand sides
- Remove the screw (1) in the air baffle (2) on both sides
- Remove the air baffle. Pull it backward.




- Remove the screws (1). Slacken off the centre air baffle (2)
- Release the catches (3). Pull the air baffle backwards
- Remove the air baffle.




- Remove the covers (1) on the right and left-hand sides.




- Install the spring nuts (1) from the kit in the hole for the mounting for the fog lamp
- Disconnect the pre-routed connector (2) from its location
- Repeat the operation on the other side.




- Install the fog lamp. Tighten using the three screws from the kit
- Repeat the operation on the other side.




- Connect the pre-routed connector to the fog lamp on the right and left-hand sides
- Reinstall the centre air baffle.

Illustration A applies only to the USA





Illustration B applies to other markets




- Remove the cover (1) on the lighting control panel
- Install the fibre optic (2) and the button (3) from the kit. Press the button into place
- Program the software. See the service information in VIDA
- Check the function. Align the lamps
- Reinstall the air baffles at the sides (if applicable).