Replacing the Relay For the Electrical Engine Block Heater

Replacing the relay for the electrical engine block heater

Note! There is a relay for the accessory electronic module which is positioned on the underneath of the left front member. This may be positioned on its own or connected via an adapter socket for a charger or electrical engine block heater.

Removal

Removing the relay




Slacken off the screws for the relay.
Disconnect the connector.
Detach the relay (from the adapter socket if applicable).

Installation

Installing the relay




Connect the connector.
Reinstall the relay (reconnect it to the adapter socket if applicable).
Tighten the screw.