Connecting Rod: Specifications

Connecting Rods










Assemble the connecting rod. Check that the cover is facing the correct direction.
Tighten 20 Nm.

Connecting rod cover
Tighten in two stages:
Tighten 20 Nm
Angle-Tighten 90 degrees

Connecting rod cap
Connecting rod with treated toothed surface between the connecting rod and cap, screw with waist
Stage 1 20 Nm
Stage 2 angle-tighten 90 degrees

Connecting rod with fracture surface between the connecting rod and cap, fully threaded screw
Stage 1 30 Nm
Stage 2 angle-tighten 90 degrees