Connecting the Breakout Box, Driver Door Module (DDM) / Passenger Door Module (PDM)

Connecting the breakout box

Special tools:
951 1428 Breakout box 951 1428 Breakout Box
951 1499 Cable 951 1499 Cable
951 1507 Adapter 12-12-8-4-2 Pin 951 1507 Adapter 12-12-8-4-2 Pin
981 3194 Replaced by 9511495 981 3194 Replaced by 951 1495

Connecting the breakout box
- Ignition off.
- Remove the door panel
- Disconnect the module connectors.

Note! Unplug the 12-pin connector before the 30-pin connector.

Connect the adapter to the control module's connector. Connect breakout box 951 1428 Breakout box 951 1428 Breakout Box and cable harness 951 1499 Cable 951 1499 Cable to the adapter.
Adapter cable harness 951 1507 Adapter 12-12-8-4-2 Pin 951 1507 Adapter 12-12-8-4-2 Pin is for the 12-pin connector, and adapter cable harness 981 3194 Replaced by 9511495 981 3194 Replaced by 951 1495 is for the 30-pin connector.
Disconnection of breakout box in reverse order.

Other information
- To remove the door panel, see Replacing the front door side panel Front Door Side Panel
- For further information about signals and other values, see Signal specification Pinout Values and Diagnostic Parameters.