Diagnostic Trouble Code (DTC) Information

Diagnostic trouble code (DTC) information

Condition




During the first ignition cycle, the Suspension Module (SUM) reads the vehicle configuration data from the central electronic module (CEM). Diagnostic trouble code (DTC) SUM-0262 may be stored if:
- a control module is installed that has previously been used in another car
- software for another model has been downloaded into the Suspension Module (SUM)
- a central electronic module (CEM) is installed that has previously been used in another car.

Note! The test is carried out every other operating cycle. The Suspension module (SUM) defines an operating cycle as ignition on and ignition off.

Substitute value
- Four-C control is switched off.

Hint: For information about abbreviations, see Suspension system, abbreviations Description and Operation.

Possible source
- A Suspension Module (SUM) from another model has been installed
- Software for another model has been downloaded into the Suspension Module (SUM)
- A central electronic module (CEM) from another model has been installed.

Fault symptom[s]
- General warning lamp lit
- Message in the display.