Configuration Fault

Configuration fault

Checking diagnostic trouble codes (DTCs) in the central electronic module (CEM)

Note! If the central electronic module (CEM) is incorrectly configured, it may affect the Suspension Module (SUM). If diagnostic trouble codes (DTCs) are stored in the central electronic module (CEM), the central electronic module (CEM) must be fault-traced first.




- Ignition on
- Read off diagnostic trouble codes (DTCs) from the Central Electronic Module (CEM).









Are diagnostic trouble codes (DTCs) stored in the central electronic module (CEM)?

Yes - DONE

No - Checking the control module

-------------------------------------------------

Checking the control module




Note! Diagnostic trouble code (DTC) SUM-0262 may be stored if the Suspension Module (SUM) has previously been installed in another car.

Was the Suspension Module (SUM) previously installed in another car?

Yes - Checking the control module

No - Downloading software

-------------------------------------------------

Checking the control module




- Check that the P/N of the control module corresponds to the number in the replacement parts catalogue. If the P/N does not match the replacement parts catalogue, replace the control module. Download new software into the control module if the P/N matches the replacement parts catalogue. Select Pause. Save this page as a bookmark and cancel the fault-tracing. Then go to the software manager and download the correct software. Then resume the fault-tracing
Note! After downloading the software, the Suspension Module (SUM) must be calibrated according to VIDA vehicle communication.

Select an option:
1. Incorrect control module P/N
2. New software downloaded.





1 - DONE

2 - Reading off diagnostic trouble codes (DTCs)

-------------------------------------------------

Downloading software
- Save a bookmark and cancel the fault-tracing. Then go to the software manager and download the correct software. Then resume the fault-tracing
Note! After downloading the software, the Suspension Module (SUM) must be calibrated according to VIDA vehicle communication.






Continue - Reading off diagnostic trouble codes (DTCs)

-------------------------------------------------

Reading off diagnostic trouble codes (DTCs)




- Ignition off
- Wait approximately 15 seconds
- Ignition on
- Read off diagnostic trouble codes (DTCs).





Is diagnostic trouble code (DTC) SUM-0262 stored?

Yes - Fault-tracing information

No - Fault Found

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - FAULT-TRACING FAILED

No - Attempt New Test

------------------------

Attempt New Test - Checking diagnostic trouble codes (DTCs) in the central electronic module (CEM)

FAULT-TRACING FAILED - FAULT-TRACING FAILED

-------------------------------------------------