Faulty Configuration

Faulty configuration

Reloading software
The suspension module (SUM) has registered an internal fault. If the fault is intermittent, the fault has been registered on a previous occasion. Intermittent faults may be caused by interference at start up of the control module.
The fault can occur on different occasions. The software may need to be reloaded. To reload software, see "Suspension module (SUM), replacing".

Other information:
- Suspension module (SUM), replacing Service and Repair



Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
In case of this defect, troubleshooting is not followed by verification.
The information can be displayed again or the fault-tracing for this fault can be interrupted.

Do you want to view the information again?

Yes - Attempt New Test

No - Fault Found

------------------------

Attempt New Test - Reloading software

FAULT FOUND - DONE

-------------------------------------------------