Non-Approved Value

Non-approved value

Checking components and wiring




- Ignition off.
- Check the connectors for the Suspension Module (SUM) and the solenoids. Check for contact resistance and oxidation
- Check the wiring between the control module and the solenoids. Check for an open-circuit
- Check that the solenoids are correctly installed.
Remedy as necessary.
After this fault-tracing, the control module must be calibrated according to VIDA vehicle communication. Select Pause. Then save a bookmark so that the fault-tracing can be resumed from this point.

Other information:
- To replace the front solenoid/shock absorber, see Shock absorber front, replacing, M58, M66 AWD, AW50/51 AWD Shock Absorber Front, Replacing
- To replace the rear solenoid/shock absorber, see Spring/shock absorber rear, replacing Spring/Shock Absorber Rear, Replacing
- For information about components, see Component specifications [1][2]Specifications
- To connect the breakout box, see Connecting the breakout box Connecting the Breakout Box, Suspension Module (SUM)
- For information about signals, see Signal specification Signal Specification, Suspension Module (SUM)
- Checking wiring and terminals Checking Wiring And Terminals.






Continue - Verification

-------------------------------------------------

Verification




Verification

Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the components, reconnect the connectors etc.
- Ignition on.
Read off the status of the diagnostic trouble code (DTC).





Is the status of the diagnostic trouble code (DTC) intermittent?

Yes - VERIFIED

No - VERIFICATION FAILEDPAPER

------------------------

VERIFIED - Fault Found

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - FAULT-TRACING FAILED

No - Attempt New Test

------------------------

FAULT-TRACING FAILED - FAULT-TRACING FAILED

Attempt New Test - Checking components and wiring

-------------------------------------------------