Faulty Software

Faulty software

Reloading software
The suspension module (SUM) has registered a fault in the software. If the fault is intermittent, the fault has been registered on a previous occasion. As the suspension module (SUM) has registered that the software is defective, the software must be reloaded. Intermittent faults may be caused by interference at start up of the control module. To reload software, see "Suspension module (SUM), replacing".

Other information:
- Suspension module (SUM), replacing Service and Repair



Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
In case of this defect, troubleshooting is not followed by verification.
The information can be displayed again or the fault-tracing for this fault can be interrupted.

Do you want to view the information again?

Yes - Attempt New Test

No - Fault Found

------------------------

Attempt New Test - Reloading software

FAULT FOUND - DONE

-------------------------------------------------