Internal Fault

Internal fault

Reloading software
Check that the battery voltage is OK.
The suspension module (SUM) has registered an internal fault. If the fault is intermittent, the fault has been registered on a previous occasion. Intermittent faults can be caused by interference at start up of the control module or by the battery voltage being too low. As the suspension module (SUM) has registered this internal fault, the software must be reloaded. To reload software, see "Suspension module (SUM), replacing".

Other information:
- Suspension module (SUM), replacing Service and Repair







Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
In case of this defect, troubleshooting is not followed by verification.
The information can be displayed again or the fault-tracing for this fault can be interrupted.

Do you want to view the information again?

Yes - Attempt New Test

No - Fault Found

------------------------

FAULT-TRACING FAILED - FAULT-TRACING FAILED

Attempt New Test - Reloading software

-------------------------------------------------