Signal Missing

Signal missing

Checking components and wiring




- Ignition off.
Check the connectors for the Suspension Module (SUM) and the acceleration sensor. Check for contact resistance and oxidation.

For diagnostic trouble code (DTC) SUM-0013, front left acceleration sensor:
- Check the signal cable between control module terminal #A12 and acceleration sensor terminal #2. Check for an open-circuit or a short-circuit to the power supply cable
- Check the ground lead between Suspension Module (SUM) terminal #A19 and acceleration sensor terminal #3. Check for an open-circuit.

For diagnostic trouble code (DTC) SUM-0023, front right acceleration sensor:
- Check the signal cable between control module terminal #A27 and acceleration sensor terminal #2. Check for an open-circuit or a short-circuit to the power supply cable
- Check the ground lead between control module terminal #A19 and acceleration sensor terminal #3. Check for an open-circuit.

Hint: Click on the VCT2000 symbol to check the signal from the acceleration sensors.

Try a new acceleration sensor if no fault is found in the wiring.
Remedy as necessary.

Other information:
- Acceleration sensor suspension front (Four-C), replacing Acceleration Sensor Suspension Front (Four-C), Replacing
- For information about components, see Component specifications [1][2]Specifications
- To connect the breakout box, see Connecting the breakout box Connecting the Breakout Box, Suspension Module (SUM)
- For information about signals, see Signal specification Signal Specification, Suspension Module (SUM)
- Checking wiring and terminals Checking Wiring And Terminals.














Continue - Verification

-------------------------------------------------

Verification




Verification

Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Ignition on.
Click on the VCT2000 symbol to read off the present value of the acceleration sensor. The value must be approximately 2.5 V
Rock the car. Check that the value changes.





Is the value OK?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - Fault Found

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - FAULT-TRACING FAILED

No - Attempt New Test

------------------------

FAULT-TRACING FAILED - FAULT-TRACING FAILED

Attempt New Test - Checking components and wiring

-------------------------------------------------