Internal Fault

Internal fault

Replacing the component




- Switch off the ignition. Wait 10 seconds.

Caution! Avoid touching the terminal pins in the occupant weight sensor (OWS). There is a risk of static discharge which could damage the occupant weight sensor (OWS).

Replace the pressure sensor and the occupant weight sensor (OWS) module. The pressure sensor and occupant weight sensor (OWS) module are included in the occupant weight sensor (OWS) system.

Note! After replacing the pressure sensor and the occupant weight sensor (OWS) module in the occupant weight sensor (OWS) system, the supplemental restraint system module (SRS) must be configured. This is done by storing the ID number for the occupant weight sensor (OWS).The occupant weight sensor (OWS) must also be calibrated.

Other information
- Occupant weight sensor (OWS), replacing Removal and Replacement
- Storing the ID number for the occupant weight sensor (OWS) Logging Detailed Diagnostics Data
- Calibrating the occupant weight sensor (OWS) Programming and Relearning



Continue - Verification

-------------------------------------------------

Verification




Verification

Verification

Hint: After carrying out the repair, check that the fault has been remedied.




- Ignition off
- Disconnect the battery negative lead
- Reinstall the connectors, components etc.
- Ignition on
- Connect the battery negative lead.

Warning! There must not be anyone inside the passenger compartment when the battery is connected.

- Read off diagnostic trouble codes (DTCs).
The fault is no longer present if the diagnostic trouble code (DTC) status is intermittent.





Is the diagnostic trouble code (DTC) intermittent?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - Fault Found

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - FAULT-TRACING FAILED

No - Attempt New Test

------------------------

FAULT-TRACING FAILED - No Fault Found

Attempt New Test - Replacing the component

-------------------------------------------------