Faulty function

Faulty function

Checking the component








- Switch off the ignition. Wait 10 seconds
- Set the switch to theONposition
- Switch on the ignition. Wait 10 seconds.
Check the current running through sensors A and B in the switch.
When the switch is in theONposition, the current level in sensor A must be in the range of 1.6-6.4 mA and the current level in sensor B must be in the range of 12.8-20.1 mA.
Click on the VCT2000 symbol to read off the current level.
Replace the switch if any of the current levels are outside the listed ranges.
- Switch off the ignition. Wait 10 seconds
- Set the switch to theOFFposition
- Switch on the ignition. Wait 10 seconds.
Check the current running through sensors A and B in the switch.
When the switch is in theOFFposition, the current level in sensor A must be in the range of 12.8-20.1 mA and the current level in sensor B must be in the range of 1.6-6.4 mA.
Click on the VCT2000 symbol to read off the current level.
Replace the switch if any of the current levels are outside the listed ranges.
SelectContinueto erase the diagnostic trouble code (DTC) if not fault is found.

Other information
- .







Continue - Verification

-------------------------------------------------

Verification




Verification

Verification

Hint: After carrying out the repair, check that the fault has been remedied.




- Ignition off
- Disconnect the battery negative lead
- Reinstall the connectors, components etc.
- Ignition on
- Connect the battery negative lead.

Warning! There must not be anyone inside the passenger compartment when the battery is connected.

- Read off diagnostic trouble codes (DTCs).
The fault is no longer present if the diagnostic trouble code (DTC) status is intermittent.





Is the diagnostic trouble code (DTC) intermittent?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - Fault Found

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - FAULT-TRACING FAILED

No - Attempt New Test

------------------------

FAULT-TRACING FAILED - No Fault Found

Attempt New Test - Checking the component

-------------------------------------------------