Internal Fault

Internal fault

Replacing and programming the SRS control module
The SRS control module has registered an internal fault.

Note! The hardware P/N for the supplemental restraint system module (SRS) must be checked if this diagnostic trouble code (DTC) is stored immediately after another control module has been programmed.

Read off ECU, hardware P/N by clicking on the VCT2000 symbol.
If the number is one of those shown below, the supplemental restraint system module (SRS) must only be reprogrammed using new software.
- 8651514
- 8651515
- 8696027
- 9467815.
If the diagnostic trouble code (DTC) is stored on another occasion or for a different type of vehicle, the supplemental restraint system module (SRS) assembly must be replaced.

Caution! A new SRS control module is delivered without software. The control module must be programmed in order to function after replacement.

Other information
- For further information about programming and replacing the SRS control module, see: Control module SRS (supplemental restraint system), replacing Service and Repair










Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
In case of this defect, troubleshooting is not followed by verification.
The information can be displayed again or the fault-tracing for this fault can be interrupted.

Do you want to view the information again?

Yes - Attempt New Test

No - Fault Found

------------------------

Attempt New Test - Replacing and programming the SRS control module

FAULT FOUND - Fault Found

-------------------------------------------------