Configuration Fault

Configuration fault

Checking the component

Caution! Do not touch the terminal pins in the supplemental restraint system module (SRS). There is a risk of static discharge. This could damage the supplemental restraint system module (SRS).




- Ignition off.
Check whether the vehicle is to be equipped with an occupant weight sensor (OWS).
If the vehicle has an occupant weight sensor (OWS) even though it should not, the passenger seat must be replaced with one without an occupant weight sensor (OWS).
If the vehicle does not have an occupant weight sensor (OWS) even though it should, the supplemental restraint system module (SRS) must be reprogrammed.
Remedy as necessary.
If no fault is found, replace the supplemental restraint system module (SRS).

Other information
- Signal specification Signal Specification, Supplemental Restraint System Module (SRS)
- For further information about cable routing and terminals, see the wiring diagram
- To program the supplemental restraint system module (SRS), see: Control module SRS (supplemental restraint system), replacing Service and Repair
- Control module SRS (supplemental restraint system), replacing Service and Repair
- Checking wiring and terminals Checking Wiring And Terminals

Select "Continue" when the fault has been remedied.

Continue - Verification

-------------------------------------------------

Verification




Verification

Verification

Hint: After carrying out the repair, check that the fault has been remedied.




- Ignition off
- Disconnect the battery negative lead
- Reinstall the connectors, components etc.
- Ignition on
- Connect the battery negative lead.

Warning! There must not be anyone inside the passenger compartment when the battery is connected.

- Read off diagnostic trouble codes (DTCs).
The fault is no longer present if the diagnostic trouble code (DTC) status is intermittent.





Is the diagnostic trouble code (DTC) intermittent?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - Fault Found

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - FAULT-TRACING FAILED

No - Attempt New Test

------------------------

FAULT-TRACING FAILED - No Fault Found

Attempt New Test - Checking the component

-------------------------------------------------