Diagnostic Trouble Code (DTC) Information

Diagnostic trouble code (DTC) information SAS-E010

Condition




The Steering wheel angle sensor module (SAS) is located in the lever module together with the steering wheel module (SWM) and is supplied with power by it.
The steering wheel angle sensor module (SAS) compares the voltage with the central electronic module (CEM).
Diagnostic trouble code (DTC) is stored if the steering wheel angle sensor module (SAS) registers that the voltage when compared to the voltage signal from the central electronic module (CEM) is lower than 2 V for 10 seconds.
The diagnostic trouble code (DTC) can be diagnosed when the ignition is switched on and the steering wheel angle sensor is initiated. Initiation is carried out when the steering wheel is turned more than 4.5° in any direction.

Substitute value
- The stability function is blocked.

Possible source
- Contact resistance or oxidation in the connectors of the steering wheel module (SWM)
- Internal fault in the steering wheel angle sensor module (SAS).

Fault symptom[s]
- Anti-spin warning lamp lit.
- General warning lamp lit.
- The stability control system does not function.