Calibration Fault

Calibration fault

Calibrating the component





Note! If the vehicle is equipped with Four-C, calibration must be carried out via suspension module (SUM).

Check that the position sensor for the Bi-Xenon lamps is correctly installed.
Someone must sit in the driver's seat during calibration. The person must weigh at least 75 kg. Ensure that the vehicle is unladen and is on a flat surface.
Calibrate the position sensor for the Bi-Xenon lamps again.
- Ignition on
- Click on the VCT2000 symbol
- Calibrate the position sensor.

Other information










Continue - Verification

-------------------------------------------------

Verification




Verification

Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Ignition on.
Check that the position sensor for the Xenon lamp is calibrated by clicking on the symbol for VCT2000.





Is the calibration OK?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - Fault Found

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - FAULT-TRACING FAILED

No - Attempt New Test

------------------------

FAULT-TRACING FAILED - FAULT-TRACING FAILED

Attempt New Test - Calibrating the component

-------------------------------------------------