Signal Too High

Signal too high

Checking the wiring








- Ignition off
- Disconnect connectors A and F on the rear electronic module (REM).
Check the signal cable. Check for an open-circuit. Check for a short-circuit to supply voltage.
For the S80 and S60
Take readings between:
- Rear electronic module (REM) terminal #A6 (#6) and terminal #1 on the connector for the high level stop lamp.
For the V70, XC70 and XC90
Take readings between:
- Rear electronic module (REM) terminal #F4 (#44) and terminal #1 on the connector for the high level stop lamp.
Remedy as necessary.

Other information
- Connecting the breakout box Connecting Breakout Box, Rear Electronic Module (REM)
- Signal specification Signal Specification, Rear Electronic Module (REM)
- Checking wiring and terminals Checking Wiring And Terminals






Continue - Verification

-------------------------------------------------

Verification




Verification

Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Ignition on.
Activate the stop lamp.
Check that the stop lamp is activated.

Is the stop lamp activated?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - Fault Found

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - FAULT-TRACING FAILED

No - Attempt New Test

------------------------

FAULT-TRACING FAILED - FAULT-TRACING FAILED

Attempt New Test - Checking the wiring

-------------------------------------------------