Internal Fault

Internal fault

Replacing the component




- Ignition off.
The driver door module (DDM) has registered an internal fault.

Note! A new control module is delivered without software. The control module must be programmed in order to function after replacement.

After replacing the control module the window position must be initialized.
- Ignition on.
Move the window to its upper limit position using manual control.
Initialize the window.
During initialization, the window will automatically go down to its lowest position and then go back up again.

Other information:
- For further information about programming and replacing the control module, see Driver's door module / passenger door module (DDM/PDM), replacing Driver's Door Module/Passenger Door Module (DDM/PDM), Replacing.






Continue - Fault Found

-------------------------------------------------