Communication Fault

Communication fault

Checking the wiring








- Ignition off
- Disconnect central electronic module (CEM) connector D.
The diagnostic trouble code (DTC) indicates that the communication between the steering wheel module (SWM) and central electronic module (CEM) is not working. This may be due to a fault in the signal cable between the control modules or a damaged communication device in one or both of the control modules.
Check the signal cable. Check for an open-circuit. Check for a short-circuit to ground.
Take readings between:
- Central electronic module (CEM) #D58 (#58) and steering wheel module (SWM) #7.
Remedy as necessary.

Other information
- Connecting the breakout box Connecting the Breakout Box, Central Electronic Module (CEM)
- Signal specification Pinout Values and Diagnostic Parameters
- Location of components Locations
- Steering wheel module (SWM), replacing Service and Repair
- Checking wiring and terminals Checking Wiring And Terminals

Was a fault detected?

Yes - Verification

No - Replacing the control module

-------------------------------------------------

Replacing the control module
Try replacing the steering wheel module (SWM).
Remedy as necessary.

Other information
- Steering wheel module (SWM), replacing Service and Repair


Continue - Verification

-------------------------------------------------

Verification




Verification

Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Ignition on.
Check that the function for the relevant button or switch is OK.

Is the function OK?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - Fault Found

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - FAULT-TRACING FAILED

No - Attempt New Test

------------------------

FAULT-TRACING FAILED - FAULT-TRACING FAILED

Attempt New Test - Checking the wiring

-------------------------------------------------