Diagnostic Trouble Code (DTC) Information

Diagnostic trouble code (DTC) information CEM-8D03

Condition
The central electronic module (CEM) checks the signal from the stop lamp switch.
The diagnostic trouble code (DTC) is stored if the control module detects that:
- Brake light is activated when Engine control module (ECM) informs that brake pedal is not depressed, and no internal error has been detected of Central electronic module (CEM).
The control module's test for the diagnostic trouble code (DTC) starts in the event of:
- Ignition position I and II, when HS-CAN is activated.

Note! The control module can only detect the fault once the test has been started and the diagnostic trouble code (DTC) is stored when the conditions are met.





Substitute value
- None.

Possible source
- Internal error in brake light switch or leads.

Fault symptom[s]
- Cruise control/Does not engage
- Cruise control/Disengagement does not work
- Cruise control/Does not remain at set speed/disengages
- Tail light/Brake lights constantly lit