Signal Too Low

Signal too low

Checking the wiring








- Ignition off
- Disconnect central electronic module (CEM) connector B.
Check the power cable for a short-circuit to ground.
For S60, V70, S80 with Bi-Xenon and XC90
Take readings between:
- Central electronic module (CEM) terminal #B4 (#B4) and right-hand stop lamp connector terminal #A2.
For S80 without Bi-Xenon
Take readings between:
- Central electronic module (CEM) terminal #B4 (#B4) and right-hand lamp housing connector terminal #A3.
Remedy as necessary.

Other information
- Connecting the breakout box Connecting the Breakout Box, Central Electronic Module (CEM)
- Signal specification Pinout Values and Diagnostic Parameters
- Location of components Locations
- Checking wiring and terminals Checking Wiring And Terminals


Continue - Verification

-------------------------------------------------

Verification




Verification

Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Ignition on.
Set the light switch to low beam.
Check that low beam is activated.

Is low beam activated?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - Fault Found

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - FAULT-TRACING FAILED

No - Attempt New Test

------------------------

FAULT-TRACING FAILED - FAULT-TRACING FAILED

Attempt New Test - Checking the wiring

-------------------------------------------------