Faulty Signal

Faulty signal

Checking the key type
Visually check to see if the key in the ignition switch is the correct type. See the illustration.
Check that the color marking (a small semi-circular plastic marking positioned on the head of the key nearest one of the short sides of the metal section) is the correct color: The correct color is gray or red.
The key is for another type of Volvo if the colour marking is black or blue.
If the color is not correct, replace the key with the color marking as above. Insert the key in the ignition switch. If there is no key the correct color, order a new key and program it.
Key, add / remove Add or Remove Key






Continue - Checking the key code

-------------------------------------------------

Checking the key code

Note! Check to see if there are several keys (with transponders) on the same key ring. These keys should be separate so that they do not touch the key being used. Also check that no other transponder, such as an electronic door key or an identity card with an integrated transponder, is near by.If there is an automatic toll road transponder in the car, this should be positioned as far from the antenna unit as possible.




- Ignition on
Read off the CODE RECEIVED parameter to see if the key code has been received by the central electronic module (CEM).
If the code has been received Yes is shown.





Has the code been received?

Yes - Checking the stored code

No - Damaged transponder

-------------------------------------------------

Damaged transponder
The key has a damaged transponder.
Order new key(s) and software.
Key, add / remove Add or Remove Key


Continue - Verification

-------------------------------------------------

Checking the stored code




- Ignition on
Read off the CODE STORED parameter to see if the key code has been stored in the central electronic module (CEM).
If the code has been stored Yes is shown.
Check all the keys belonging to the car.
Make a note of the keys that are not stored.





Is the code stored for all keys?

Yes - Verification

No - Programming keys

-------------------------------------------------

Programming keys
Program the key(s) which displayed NO, when CODE STORED was read off according to:
Key, add / remove Add or Remove Key


Continue - Verification

-------------------------------------------------

Verification




Verification

Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Try to start the car with all the keys (of the correct type).

Does the car start with all the keys?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - Fault Found

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - FAULT-TRACING FAILED

No - Attempt New Test

------------------------

FAULT-TRACING FAILED - No Fault Found

Attempt New Test - Checking the key type

-------------------------------------------------