Communication Fault

Communication fault

Replacing the antenna unit
The antenna unit has registered an internal fault.
If the fault is intermittent, it has been registered previously but is no longer present. Intermittent faults can be caused by interference at start up of the antenna module (ATM) or can be a different type of fault which occurs on different occasions. The fault is evaluated depending on how it occurs. If the fault recurs, replace the antenna unit.

Hint: The diagnostic trouble code (DTC) can also be stored by temporary interference in the communication with the antenna unit. If this is the case the antenna unit need not be replaced and the diagnostic trouble code (DTC) can be erased.

Antenna unit immobilizer, replacing Service and Repair
Remedy as necessary.






Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
In case of this defect, troubleshooting is not followed by verification.
The information can be displayed again or the fault-tracing for this fault can be interrupted.

Do you want to view the information again?

Yes - Attempt New Test

No - Fault Found

------------------------

Attempt New Test - Replacing the antenna unit

FAULT FOUND - DONE

-------------------------------------------------