Signal Too High
Signal too high
Checking the function of the water pump
- Ignition on.
- Activate the water pump.
Listen for a buzzing sound which indicates that the water pump is running.
Is the water pump working?
Yes - Checking components and wiring
No - Checking components and wiring
-------------------------------------------------
Verification
Verification
Verification
Hint: After carrying out the repair, check that the fault has been remedied.
- Ignition off
- Reinstall the connectors, components etc.
- Ignition on
- Activate the water pump.
Listen for a buzzing sound which indicates that the water pump is running.
Is the water pump working?
Yes - VERIFIED
No - VERIFICATION FAILEDPAPER
------------------------
VERIFIED - Fault Found
VERIFICATION FAILED - Fault-tracing information
-------------------------------------------------
Fault-tracing information
Information
Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.
Do you want to exit fault-tracing?
Yes - FAULT-TRACING FAILED
No - Attempt New Test
------------------------
FAULT-TRACING FAILED - FAULT-TRACING FAILED
Attempt New Test - Checking the function of the water pump
-------------------------------------------------
Checking components and wiring
Check the cable between combustion preheater module (CPM) terminal #12 and water pump terminal 1. Check for a short-circuit to supply voltage.
Hint: With the ignition on and the water pump connector disconnected, the voltage between water pump terminal 1 (control module side) and ground should be approximately 0 V.
The water pump must be replaced if no faults are found in the cable.
Remedy as necessary.
Other information
- Connecting the breakout box Connecting the Breakout Box
- Signal specification Signal Specification
- Water pump engine coolant heater, replacing Service and Repair
- Checking wiring and terminals Checking Wiring And Terminals
Continue - Verification
-------------------------------------------------
Checking components and wiring
Check the cable between combustion preheater module (CPM) terminal #12 and water pump terminal 1. Check for an intermittent short-circuit to supply voltage.
Remedy as necessary.
Other information
- Connecting the breakout box Connecting the Breakout Box
- Signal specification Signal Specification
- Water pump engine coolant heater, replacing Service and Repair
- Checking wiring and terminals Checking Wiring And Terminals
Continue - Verification
-------------------------------------------------