Internal Fault

Internal fault

Replacing the component
A diagnostic trouble code will be generated if the central electronic module (CEM) detects an internal fault in the right camera module (RCM).
If the fault is intermittent it will have been registered earlier but no longer exists. Intermittent faults could be due to interference on starting up or to another type of fault than recurs at different times. The seriousness of the fault is determined from case to case.
Remedy as necessary.

Other information
- Change the right camera module (RCM), see: Door mirror, replacing Service and Repair






Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
In case of this defect, troubleshooting is not followed by verification.
The information can be displayed again or the fault-tracing for this fault can be interrupted.

Do you want to view the information again?

Yes - Attempt New Test

No - Fault Found

------------------------

Attempt New Test - Replacing the component

FAULT FOUND - DONE

-------------------------------------------------