Activated too long

Activated too long

Checking the control
The diagnostic trouble code (DTC) is stored when a button or switch has been depressed for a long time.
If the fault is intermittent, it has been registered previously but is no longer present. Intermittent faults can be caused by interference at start up or can be a different type of fault which occurs on different occasions. The fault is evaluated depending on how it occurs.
Check that the button or switch does not stick in the activated position.
Remedy as necessary.

Other information
Turn signal switch, replacing Turn Signal Switch, Replacing

Continue - Verification

-------------------------------------------------

Verification




Verification

Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Ignition on.
Check that all functions are working on the turn signal lamp switch.

Does the switch function?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - Fault Found

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - FAULT-TRACING FAILED

No - Attempt New Test

------------------------

FAULT-TRACING FAILED - FAULT-TRACING FAILED

Attempt New Test - Checking the control

-------------------------------------------------