Cargo Compartment Wall

Cargo compartment wall
















INTRODUCTION
- NOTE! Read through the whole installation instruction before starting the work.
- The front page gives the date of this edition and the edition it replaces
- The second page shows the tools needed for the installation and the contents of the installation kit
- The illustrations display the procedure in order of operation. The order of operation is repeated in the text section
- Cut out the text page in order to follow the illustrations and text at the same time.






Cargo compartment wall




- Before installing check the measurement at point A = 333 mm. Adjust as necessary.




- Position the cargo compartment wall with the clamps into the car.
- Open the upper clamp and affix it loosely on the top bar of the safety grille.
- Open the lower clamp and affix it as illustrated. Tighten the clamps only exactly as much as necessary to grip the grille, do not tighten them yet.




- Adjust so that the cargo compartment wall is vertical and in the centre of the cargo compartment.
- The support plate (1) must be parallel with the roof panel.
- Screw down the rear support foot (2) so that the cargo compartment wall is tensioned.
- Screw down the front support foot (3) so that the cargo compartment wall stands in a straight, vertical position.




- Tighten the knobs (1) and (2).
- Check that the cargo compartment wall does not make contact with the tailgate when it closes.