Activated too long

Activated too long

Checking switches




- Ignition on.
Check the function of the right rear outer lock button by clicking on the VCT2000 symbol.
The value for the switch should be Activated when the button is pressed in.









Is the function OK?

Yes - Fault-tracing information

No - Checking the wiring

-------------------------------------------------

Fault-tracing information
The keyless vehicle module (KVM) has previously registered a fault but the fault no longer exists. The diagnostic trouble code (DTC) is probably caused by an intermittent fault or a lock button has been held in for an unusually long time. If the fault persists, fault-tracing according to this diagnostic trouble code (DTC) must be carried out despite no fault symptoms being found. The fault is evaluated depending on how it occurs.


Continue - No Fault Found

-------------------------------------------------

Checking the wiring




- Ignition off.
Check the cable between the keyless vehicle module (KVM) and the right rear outer lock button. Check for an open-circuit. Check for a short-circuit to ground.
Check the ground lead between the door handle and the ground terminal. Check for an open-circuit. Check for a short-circuit to ground.
Check the ground terminal. Check for loose connections and oxidation.
Remedy as necessary.

Other information
- Connecting the breakout box Connecting The Breakout Box, Keyless Vehicle Module (KVM)
- Signal specification Signal Description, Keyless Vehicle Module (KVM)
- Checking wiring and terminals Checking Wiring and Terminals





Was a fault detected?

Yes - Verification

No - Replacing the component

-------------------------------------------------

Replacing the component
If no other fault is discovered, the door handle should be replaced.

Other information
- Outer handle, rear door Service and Repair


Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Ignition on.
Check the function of the lock button in the relevant outer door handle by clicking on the VCT2000 symbol. Then press the lock button in.
The value for the lock button should be Activated when the button is pressed in.





Is the function OK?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFICATION FAILED - Fault-tracing information

VERIFIED - Fault Found

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit Fault-Tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking switches

-------------------------------------------------