Wastegate Actuator: Service and Repair

Actuator turbo pressure (vacuum)

Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.

Removal

Removing the turbocharger (TC) control valve




Raise the vehicle.

Remove:
- lower the engine cover, if installed. Disconnect the connector for the turbocharger (TC) control valve
- the screws for the turbocharger (TC) control valve
- the hoses for the turbocharger (TC) control valve. Note the position of the hoses to facilitate installation.

Installation

Note! For tightening torques, see Specifications. Tightening Torque.

Installing the turbocharger (TC) control valve

Install:
- the hoses for the turbocharger (TC) control valve. See earlier markings
- the screws for the turbocharger (TC) control valve. Tighten
- the lower engine cover, if installed.