Via CAN-Communication

Via CAN-Communication

Central Electronic Module (CEM):
- Central Electronic Module (CEM):
- Outdoor temperature
- Clutch pedal position
- Accelerator pedal position (analogue signal from accelerator pedal sensor)
- Fuel quantity in tank
- Start operation blocking
- Charging current request
- Time after engine cut-off
- Increased idle running speed request.

Brake Control Module (BCM):
- Brake pedal position
- Vehicle speed
- Active control function
- Front wheel spinning for detection of "rough road"
- Torque limiting request.

Climate Control Module (CCM):
- A/C-compressor request
- Increased cooling fan speed request
- Request for lowest idle running speed allowed
- Evaporator temperature.

Transmission Control Module (TCM):
- Torque limiting request
- Oil temperature gearbox
- Chosen gear position
- Status on "Lock-up" (connected/disconnected)
- Request for lowest idle running speed allowed
- Transmission ratio
- Torque loss in gearbox.

Steering Wheel Module (SWM):
- Cruise control request
- Steering angular.

Climate Control Module (CCM):
- A/C-compressor status
- Ambient pressure
- Engine temperature
- Engine speed
- Engine status (on/off).

Transmission Control Module (TCM):
- Load
- Cruise control status
- Engine temperature
- Engine speed
- Accelerator pedal position
- Brake pedal status (depressing/not depressing)
- Cruise control set speed
- Engine status (on/off)
- "Kick down" request.

Combi instrument (DIM):
- Engine temperature
- Warning texts related to ECM
- Engine speed
- Cruise control status
- Estimated fuel consumption
- Engine status (on/off)
- Oil pressure status
- Oil level
- Service time.

Differential Electronic Module (DEM):
- Engine speed
- Accelerator pedal position
- Brake pedal status (depressing/not depressing)
- Engine status (on/off).

Electronic Power Steering (EHPAS):
- Engine speed
- Engine status (on/off)

Central Electronic Module (CEM):
- Fuel pump request
- Engine speed
- Load
- MIL lighting request
- Charging current from generator
- Engine status (on/off)
- Generator status
- Codes for starter inhibitor function (immobilizer)
- Cruise control status (on/off).

Brake Control Module (BCM):
- Torque after gearbox
- Engine speed
- Brake pedal status (depressing/not depressing)
- Accelerator pedal position
- Engine status (on/off).