Connector Anti-Lock Braking System Module (ABS)

Cables

Connector anti-lock braking system module (ABS)

Special tools:
951 2630
951 2631

NOTE: The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.

Disassembly

Disassembling secondary lock





Disconnect the secondary lock. Use an electrician's screwdriver, as illustrated.

CAUTION: Disconnect and work with only one cable at a time to minimize the risk of mixing them up.

Disassembling primary lock





Use tool: 951 2630 and tool: 951 2631 to remove the primary lock.
At the same time pull the cable carefully backwards.

Assembly

NOTE: Wheel sensor cables are twisted pair (positive and negative signal) cables for each wheel. It is important that paired cables are twinned in the same way when they are reinstalled in the connector. The cables must be twisted approximately 3 times per 100 mm.

Assembling primary lock
Check that the cable terminal is undamaged.

Press the cable terminal into the housing.

Check that the cable terminal is properly locked by pulling carefully on the cable.

Assembling secondary lock
Press the secondary lock into place.