Actuator Damper Climate Control System Driver's Side

Actuator damper climate control system driver's side

Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.

Preparatory work

Important information
The are 2 damper motor modules (DMM) for temperature, one on the right and one on the left-hand side.

Removing the dashboard
Remove the dashboard. See: Dashboard Dashboard.

Removal

Removing the damper motor module (DMM) for temperature




Disconnect the connector.

Hint: Using a small electrician's screwdriver, pry up the connector at the lock. Pull the connector off.

Remove:
- the 3 screws
- the control module.

Installation

Installing the damper motor module (DMM) for temperature

Install:
- the control module in position. Adjust the shaft journal so that it goes in
- the 3 screws. Tighten crosswise
- the switch
- the dashboard. See: Dashboard Dashboard.

Note! Identify the damper motor module (DMM) temperature. See VIDA Vehicle communication.

Finishing

Testing the climate control system
Carry out a performance test on the climate control unit. See: Climate control system, check Climate Control System, Check.