Power Seat Module, Left (PSL)

Programming remote control setting

Programming remote control setting
On vehicles equipped with power seats with memory, the seat automatically assumes the position that corresponds to the remote control used.
The memory function of the seat can be deactivated. If the function is deactivated, the seat does not assume the seat position when the vehicle is unlocked with the remote control. The seat memory position is then set using the memory buttons on the seat control panel.
Follow the instructions below to change the setting of how the seat is to react when the remote control is used.




- Ignition on.
- Click the VCT2000 symbol to read the setting of the power seat module, left (PSL).
Change the setting by marking the desired alternate and programming. Check that the read value is changed to the desired alternative.

Continue - DONE

-------------------------------------------------