Short-Circuit to Ground

Short-circuit to ground

Checking the cable








- Ignition off.
- Disconnect the connector for the left-hand subwoofer behind the rear seat.
- Disconnect the 16-pin connector for the Subwoofer module (SUB).
Check the cable terminals in the female and male sections of the connector. The cable terminals must not be damaged or pressed back.
Check the signal cable between the Subwoofer module (SUB) terminal #B5 and right-hand bass speaker terminal #2. Check for a short-circuit to ground.
Check the signal cable between the Subwoofer module (SUB) terminal #B12 and right-hand bass speaker terminal #1. Check for a short-circuit to ground.
Remedy as necessary.

Other information
- Signal specification Signal Specification, Subwoofer Module (SUB)
- Connecting the breakout box Breakout Box Connection, Subwoofer Module (SUB)
- Rear Seat Backrest Speaker Rear Seat Backrest Speaker
- Subwoofer module (SUB) Subwoofer Module (SUB)
- Checking wiring and terminals Checking Wiring and Terminals





Continue - Verification

-------------------------------------------------

Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off.
- Reinstall the connectors, components etc.
- Ignition on.
Check that there is sound from the loudspeakers for the Subwoofer module (SUB).

Is the function OK?

Yes - Troubleshooting procedure complete

No - Replacing a component

-------------------------------------------------

Replacing a component
The subwoofer module (SUB) has registered an internal fault.
If the fault is intermittent it means that it has been registered previously but is no longer present. Intermittent faults can occur for a number of different reasons. The fault is evaluated depending on how it occurs.
In the event of a permanent fault, replace the subwoofer module (SUB).

Other information
- Subwoofer module (SUB) Subwoofer Module (SUB)





Is the function OK?

Yes - Troubleshooting procedure complete

No - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit Fault-Tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking the cable

-------------------------------------------------