Activated Too Long
Activated too long
Checking the component
- Ignition on.
Check if the switch is sticking due to dirt or there is an obstruction preventing the switch from returning.
Note! If the SOS- or ON CALL-button is held pressed in for at least two seconds one of the services will be activated. The phone module (PHM) will then make a call to Volvo On Call Service Center. An activated ON CALL service can be cancelled by pressing the NO button twice. An activated SOS service can only be cancelled by the Volvo On Call Customer Service Center.
The keypad must be replaced if the switch does not spring back and the fault is not due to dirt or an external object.
Click on the VCT2000 symbol to check how the phone module (PHM) interprets the status of the switch.
Other information:
- Signal specification Signal Specification, Phone Module (PHM)
- Connecting the breakout box Connecting the Breakout Box, Phone Module (PHM)
- Location of components Location of Components, Phone Module (PHM)
- Phone Module (PHM) Phone Module (PHM)
- Checking wiring and terminals Checking Wiring and Terminals
Was a fault detected?
Yes - Verification
No - Fault-tracing information
-------------------------------------------------
Fault-tracing information
The fault is probably because a switch has been activated for too long during individual operating cycles. No further corrective action is required if the diagnostic trouble code (DTC) does not recur.
Continue - Verification
-------------------------------------------------
Verification
Hint: After carrying out the repair, check that the fault has been remedied.
- Ignition off
- Reinstall the connectors, components etc.
- Ignition on
- Activate the carphone.
Make a call so that both the handset and the hands-free system are used. See the instruction manual.
Ignition off.
Ignition on.
Read off the diagnostic trouble codes (DTCs).
Check that the relevant diagnostic trouble code (DTC) has switched status from permanent to intermittent fault.
Has the status of the diagnostic trouble code (DTC) changed?
Yes - Troubleshooting procedure complete
No - Fault-tracing information
-------------------------------------------------
Fault-tracing information
Information
Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.
Do you want to exit fault-tracing?
Yes - Exit Fault-Tracing
No - Attempt New Test
-------------------------------------------------
Information
Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).
Do you want to view the information again?
Yes - Attempt New Test
No - Exit Fault-Tracing
------------------------
Attempt New Test - Checking the component
-------------------------------------------------