Stuck in the Active Position

Stuck in the active position

Replacing a component
A condition of fault tracing is that the Diagnostic Trouble Code (DTC) is not generated because the button for both opening/closing has been held in for too long.
If the fault is intermittent, it has been registered previously but is no longer present. Intermittent faults can occur for a number of different reasons. The fault is evaluated depending on how it occurs.
In the event of a permanent fault, replace the control panel for the Driver door module (DDM).

Other information
- Rotary switch, front door window regulator Service and Repair





Continue - Verification

-------------------------------------------------

Verification









Hint: After carrying out the repair, check that the fault has been remedied.

- Ignition off.
- Reinstall the connectors, components etc.
- Ignition on.
Check that the control for both opening/closing functions.

Hint: Check the function of the button by clicking the VCT2000 symbol.









Is the button working?

Yes - FAULT FOUND

No - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit Fault-Tracing

No - Attempt New Test

------------------------

Attempt New Test - Replacing a component

-------------------------------------------------