Diagnostic Trouble Code (DTC) Information

Diagnostic trouble code (DTC) information CRM-E003

Condition
The control module compares its configuration ID with the signal configuration transmitted on the control area network (CAN) by the central electronic module (CEM).
If the configuration IDs do not correspond the fault code is stored.

Note! In the event of an open-circuit in both the control area network (CAN) cables, it is not possible to communicate with the control module. Therefore it will only be possible to read off the fault if it is intermittent. When the diagnostic trouble code (DTC) is stored, the control module responds to the diagnostic commands.





Substitute value
- None.

Possible source
- Incorrect CAN configuration ID.
- Open-circuit in the control area network (CAN).

Fault symptom[s]
- Push button does not work
- Lockable storage doesn't work
- Antenna extension or retraction not working