Internal Fault

Internal fault

Replacing the component
The combustion preheater module (CPM) has registered an internal fault.
If the fault is intermittent, it has been registered previously but is no longer present. Intermittent faults can be caused by interference at start up of the combustion preheater module (CPM) or may be a different type of fault which occurs on different occasions. The fault is evaluated depending on how it occurs. Replace the combustion preheater module (CPM) if the fault recurs.
Replace the combustion preheater module (CPM) in the event of a permanent fault.
Remedy as necessary.

Other information
- Combustion preheater module (CPM), replacing Combustion Preheater Module (CPM), Replacing





Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
In case of this defect, troubleshooting is not followed by verification.
The information can be displayed again or the fault-tracing for this fault can be interrupted.

Do you want to view the information again?

Yes - Attempt New Test

No - Exit Fault-Tracing

------------------------

Attempt New Test - Replacing the component

FAULT FOUND - DONE

-------------------------------------------------