Calibration Fault

Calibration fault

Calibrating the component
- Ignition on
- Light switch in position 2.
Check that the position sensors are correctly installed.
Ensure that the car is unladen and is on a flat surface.
To program the gas discharge lamp module (GDL) with vehicle parameters and to calibrate the position sensor, see Calibration of position sensor, GDL lamps Testing and Inspection.

Other information:
- Connecting the breakout box Connecting the Breakout Box, Central Electronic Module (CEM)
- Signal specification Signal Description, Central Electronic Module (CEM)
- Control module relay box passenger compartment Service and Repair
- Position sensor rear, headlamp Position Sensor Rear, Headlamp
- Checking wiring and terminals Checking Wiring and Terminals





Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Ignition on
- Light switch in position 2.
Switch between high and low beam.
Check that the function is OK.

Is the function OK?

Yes - Troubleshooting procedure complete

No - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit Fault-Tracing

No - Attempt New Test

------------------------

Attempt New Test - Calibrating the component

-------------------------------------------------